Kyocera KM-1530

Finishing
5-8 KX Driver
3
Click the Finishing tab, then select Separation. The Offset jobs option is selected.3
4
Click OK to return to the Print dialog box. 4
5
Click OK to start printing. 5
Your print job will be stacked in the output tray, offset from other jobs in the same tray.
Rotate Copies
Rotate copies stacks each copy of a print job at right angles in the output tray.
This feature requires the following:
• A Hard disk must be installed or a RAM disk enabled. For further details, refer to
Installing Optional Devices on page 2-1.
• Paper size selections are limited to Letter, A4, 16K, or B5 (JIS).
• The selected paper size must be loaded into two paper sources, one horizontally
and one vertically.
• The print job must contain multiple pages and be specified to print multiple
copies.
1
From the application’s Print dialog box, open Properties. (Select Print from the File
menu, and select Properties.) 1
2
In the Basic tab, under Destination, select an option that is not a finishing tray, for
example: Printer default or Inner tray. 2
3
Select a number of copies greater than 1. 3
4
Click the Finishing tab, then select Separation. The Rotate copies option is
selected. 4
5
Click OK to return to the Print dialog box. 5