Kyocera KM-3050 - Page 117

FAX Operation (Advanced)
OPERATION GUIDE 4-51
4
For the setting method when the machine receives originals, refer to
Memory Forwarding on page 4-16.
1
Press the Send key.
2
Place the originals.
3
Press [FAX No. Entry].
NOTE: When a sub address has been registered to the destination of the
Address Book, you can use the destination. When a sub address-
registered destination in the Address Book is used for a One-touch key,
you can also use the One-touch key. In this case, go to step 9.
4
Use the numeric
keys to enter the fax
number of the other
party.
5
Press [Sub Address].
6
Press [Sub Address
Max 20 digits] and
enter the sub
address using the
numeric keys.
NOTE: You can use up to 20 digits including the numbers from 0 to 9,
‘ (space)’, ‘#’ and ‘*’ characters to enter a sub address.
7
Press [Password] and enter the sub address password using the numeric
keys.
NOTE: You can use up to 20 digits including the numbers from 0 to 9,
‘ (space)’, ‘#’ and ‘*’ characters to enter a sub address password. When
the machine receives originals, a sub address password is not used.
Status
OK
10/10/2007 10:00
SpacePause
Ready to send.
Back Space
Sub Addres s
Transmission
Start Speed
ECM
Encrypted
Transmission
CancelNext Dest.Add t o Addr Book
Add a new FAX dest ination.
Enter the FAX number with the numeric keys.
FAX No. Entry
Enter Destination.
Destination
On Hook
0
Status
OK
10/10/2007 10:00
Sub Addres s
Max. 20 di gi ts
Ready to send.
Cancel
FAX No. Entry - Sub Address
Enter Destination.
Destination
Password
0
Set s ub addres s.
Enter s ub address and pass word
using num eric keys . (Up to 20 di gits .)
Space Back Space