Kyocera KM-3050 - Page 86

FAX Operation (Advanced)
4-20 OPERATION GUIDE
NOTE: For details on forwarding settings, refer to Forwarding Detail
Settings on page 4-25.
11
Press [OK]. Memory forwarding is set.
12
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Registration of Forwarding Settings (for Each Requirement)
To perform forwarding settings for each reception requirement, follow the
steps below. Up to 100 requirements for forwarding can be registered.
1
Press the System Menu key.
2
Press [FAX/i-FAX], and then [Next] of Forward Setting.
3
Press [Change Setting by Requirement].
4
Press [Add].
5
Press [Change] of
Requirement Name.
6
Enter the requirement name, and press [OK].
NOTE: For details on character entry, refer to Character Entry Method on
page 2 of the Appendix.
Up to 32 characters can be entered for the requirement name.
Status
FAX/i-FAX - RX/Forward Requirements
Cancel OK
10/10/2007 10:00
Print or forward the received file according to
requirements.
Off
Others
Add
Change Setting
by Requirem ent
Off
Use Requirements
for All RX
On Requirement Name
Delet eDetail/Edit
FAX A
FAX B
1/1
Status
Requirement :
Cancel Register
10/10/2007 10:00
Requirement Name :
Forward Setting:
Storing in FAX Box:
Off
File Name:
doc
Requirement :
Sub Addres s
Print:
Off
Activating Time:
Change
Next
Change
Change
Change
Change
Change
All Day