Kyocera TASKalfa 181

Basic
Flip on short edge
Printing in Duplex Mode
1
In the Basic tab, select Print on both sides.
2
Select either Flip on long edge or Flip on short edge.
Collation
Collate specifies the order in which the pages of a multiple copy job are printed.
With Collate selected, the first time the print job is sent to the printing system
the data is rendered as page images in the printing system's memory. The
remaining job copies are printed from the stored data. This avoids the extra
processing involved in sending every copy from the computer to the printing
system.
With Collate selected, the driver prints the complete job set by set. With Collate
cleared, it prints each page by set. For example, with Collate selected, three
copies of a five-page document outputs as pages one through five in
succession, three times.
Printing Collated Documents
When printing multiple copies of a multiple page document, the printer can
assemble the pages of each copy in numerical order.
1
In your application, open the Print dialog box and click Properties.
2
In the Basic tab, select the Collate check box.
3
Type or select the number of complete sets of the print job in the Copies box.
The document page count must not exceed the printer tray capacity.
4
Click OK to return to the Print dialog box, and click OK to begin printing.
User Guide
4-4