2LK/2LN/2LM/2LC-2
1-3-43
U052 Setting the fuser motor control
Description
Enters the sensor data values described on the supplied sheet provided when the loop sensor is
replaced and performs correction processing for the fuser motor.
Purpose
To perform when replacing the loop sensor or paper conveying unit.
Method
1. Press the start key.
2. Select the item.
Method: [Set Loop Sensor]
1. Select [Scanning Board1].
2. Enter the sensor data value of supplied sheet DATA1 using
the +/- keys.
3. Select [Scanning Board2].
4. Enter the sensor data value of supplied sheet DATA2 using
the +/- keys.
5. Press the start key. The value is set.
Setting: [Loop Sensor Control]
1. Select the item.
2. Select On or Off.
3. Press the start key. The setting is set.
Setting: [Set Loop Sensor Valid]
1. Select On or Off.
Initial setting: On
2. Press the start key. The setting is set.
Completion
Press the stop key. The indication for selecting a maintenance item No. appears.
Item No. Description
Display Description
Set Loop Sensor Enter the data value for loop sensor
Loop Sensor Control Set the loop sensor detection control
Set Loop Sensor Valid Sets the presence or absence of the loop sensor
Chk Loop Sensor Display the data value for loop sensor
1(e.g.)
How to read the sensor data value
2
3
4
5
6
7
8
9
0
364
Display Description Initial setting
No.1 Sensor detection On/Off setting at 125 to 250 mm from
the top of paper
On
No.2 Sensor detection On/Off setting at 250 to 290 mm from
the top of paper
On
No.3 Sensor detection On/Off setting at 300 to 330 mm from
the top of paper
On
No.4 Sensor detection On/Off setting at 350 to 370 mm from
the top of paper
On
To Next Page
Loading...
