2LK/2LN/2LM/2LC-2
1-3-98
U147 Setting for toner applying operation
Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying
operation).
Purpose
Changing settings are not required. However, when the documents with lower print density (e.g.
less than 2%) should customarily printed in a great volume, mode must be changed.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the start key.
2. Select the item to be set.
Setting: [Mode]
1. Select the mode.
Initial setting; Mode1
2. Press the start key. The setting is set.
Setting: [Upper Limit]
1. Change the setting value using the +/- keys or numeric keys.
2. Press the start key. The value is set.
Setting: [Minimum]
1. Change the setting value using the +/- keys or numeric keys.
2. Press the start key. The value is set.
Item No. Description
Display Description
Mode Settings for toner applying operation
Upper Limit Upper limit printing ratio of toner applying quantity with each mode
Minimum Toner layer width when cleaning mode is selected
Interval Number Toner collection operational interval
Display Description
Mode0 Less consumption of toner than a regular toner applying operation
Mode1 Executes toner applying with the regular amount of toner
Mode2 More consumption of toner than a regular toner applying operation
Display Description
Setting
range
Initial
setting
Value Upper limit printing ratio of toner applying
quantity with each mode (%)
0 to 10.0 2.0
Display Description
Setting
range
Initial
setting
Value Toner layer width when cleaning mode is
selected (mm)
0 to 30 10
To Next Page
Loading...
