Kyocera TASKalfa 3050ci - Page 568

2LK/2LN/2LM/2LC-2
2-3-18
YC6
1 GND - - Ground
Connected to
feed PWB 1
2 JOB_SET I 0/3.3 V DC Job separator set signal
3 JOB_MOT_REM O 0/3.3 V DC JSEM: On/Off
4 JOB_MOT_CLK O 0/3.3 V DC (pulse) JSEM clock signal
5 JOB_MOT_DIR O 0/3.3 V DC JSEM drive switch signal
6 JOB_OPEN_SEN
S
I 0/3.3 V DC JSOCS: On/Off
7 JOB_SOL_REM O 0/24 V DC JSFSSOL: On/Off
8 GND - - Ground
9 MAIN_HEAT_RE
M
- - Not used
10 SUB_HEAT_REM - - Not used
11 ZEROC - - Not used
12 FSR_RELAY O 0/3.3 V DC Fuser relay signal
13 PRESS_REM - - Not used
14 EXIT_REAR_FAN
_L
O 0/24 V DC ERFM: On/Off
15 EXIT_REAR_FAN
_H
O 0/24 V DC ERFM: On/Off
16 GND - - Ground
17 FSR_CL_REM - - Not used
18 FSR_MOT_REM O 0/3.3 V DC FUM: On/Off
19 FSR_MOT_CLK 0/3.3 V DC (pulse) FUM clock signal
20 FSR_MOT_RDY O 0/3.3 V DC FUM ready signal
21 FSR_MOT_DIR O 0/3.3 V DC FUM drive switch signal
22 FSR_MOT_BRK O 0/3.3 V DC FUM break signal
23 GND - - Ground
24 MPF_TABLE I 0/3.3 V DC MPTSW: On/Off
25 MPF_WID1 I 0/3.3 V DC MPPWSW: On/Off
26 MPF_WID2 I 0/3.3 V DC MPPWSW: On/Off
27 MPF_WID3 I 0/3.3 V DC MPPWSW: On/Off
28 MPF_LNG I 0/3.3 V DC MPPLSW: On/Off
29 GND - - Ground
30 MPF_PPR_SET I 0/3.3 V DC MPPS: On/Off
31 MPF_LIFT_UP I 0/3.3 V DC MPLS1: On/Off
32 MPF_LIFT_DOW
N
I 0/3.3 V DC MPLS2: On/Off
33 MPF_JAM I 0/3.3 V DC MPFS: On/Off
Connector Pin Signal I/O Voltage Description