Kyocera TASKalfa 3050ci - Page 609

2LK/2LN/2LM/2LC-2
2-3-59
YC3
16 EXIT_PAPER_SE
NS
O 0/3.3 V DC EFS: On/Off
Connected to
engine PWB
17 EXIT_FEED_SEN
S
O 0/3.3 V DC SBS: On/Off
18 SB_MOT_REM I 0/3.3 V DC EM: On/Off
19 SB_MOT_PH I 0/3.3 V DC EM control signal
20 SB_MOT_CLK I 0/3.3 V DC (pulse) EM clock signal
21 SB_MOT_PD I 0/3.3 V DC EM control signal
22 SB_MOT_DIR I 0/3.3 V DC EM drive switch signal
23 GND - - Ground
24 DLP_FAN_ Bk _H I 0/24 V DC DEVFM2: On/Off
25 DLP_FAN_ Bk _L I 0/24 V DC DEVFM2: On/Off
26 DLP_FAN_CLR_
H
I 0/24 V DC DEVFM1: On/Off
27 DLP_FAN_CLR_L I 0/24 V DC DEVFM1: On/Off
28 WTNR_FULL O Analog WTS2 detection signal
29 WTNR_NEAR O Analog WTS2 detection signal
30 WTNR_VCONT I 0/3.3 V DC WTS2 control signal
31 GND - - Ground
32 ROT_MOT_REM - - Not used
33 ROT_MOT_CLK - - Not used
34 ROT_MOT_PD - - Not used
35 ROT_MOT_DIR - - Not used
36 ROT_HP_SENS - - Not used
37 THOP_MOT_Bk_
REM
- - Not used
38 THOP_MOT_M_R
EM
- - Not used
39 THOP_MOT_C_R
EM
- - Not used
40 THOP_MOT_Y_R
EM
- - Not used
41 GND - - Ground
42 ENCODE_ Bk - - Not used
43 ENCODE_M - - Not used
44 ENCODE_C - - Not used
45 ENCODE_Y - - Not used
46 THOP_ Bk - - Not used
47 THOP_M - - Not used
Connector Pin Signal I/O Voltage Description