6 INSTALLING SCAN DRIVER AND UTILITIES
Installing Scan Driver and Utilities 143
Installing Scan Driver and Utilities
This section describes how to install the scan driver and utilities.
Installing the scan driver and utilities using the installer
This procedure describes an installation on Windows Vista. The procedure is the same when other versions of Windows
are used. However, you need to follow a different procedure when you install WIA driver into Windows Vista or Windows
Server 2008. For the installation procedure for these office systems, see the following page:
P.145 “Installing WIA driver to Windows Vista / Windows Server 2008”
y You must log into Windows as a user who has the “Administrators” or “Power Users” privilege. You must log into
Windows as a user who has the “Administrators” privilege when using Windows XP/Vista/Server 2003/Server
2008.
y Only users with the administrator privilege can perform this. For users without the administrator privilege,
installation is possible by performing the following procedure and having the administrator privilege temporarily.
- Double-click [Open folder to view files] in the AutoPlay menu.
- Open the “Setup” folder, right-click “Setup.exe” and then select [Run as administrator].
- Enter the administrator's password of the client computer to operate with an administrator's privilege and click
[OK].
1
Insert the Client Utilities CD-ROM into the CD-ROM drive.
y If the installer does not automatically start, use the Explorer to open the “Setup” folder in the Client Utilities CD-
ROM and double-click “Setup.exe”.
2
Select [I agree to the terms of the License Agreement.] and click [Next].
y To change the display language, select a desired language from the [Select Language] box.
y The main menu window is displayed.
3
Click [Scan Utility].
To Next Page
Loading...
