Kyocera TASKalfa 650c

Setup Flow for Windows 11
Setup Flow for Windows
After completing each procedure, please mark the check box (  ) in front of each procedure so
that you can make sure that you have completed each step for setup.
For SMB Printing
 Connecting the GA-1310/E
Connect the GA-1310/E to your network with a network cable.
 Setting up TCP/IP
Configure the TCP/IP Setup options to assign the IP Address, Subnet Mask, and Gateway
Address on the GA-1310/E to enable Fiery WebSetup from the control panel.
 Setting up the Printing Service
Configure the Windows Print Sharing to enable the Windows Printing Service from Fiery Web-
Setup or Command WorkStation.
 Installing the Printer Driver
Install the printer driver to use SMB printing.
 Configuring the Options
Configure the option settings on the printer driver.
REFERENCE for GA-1310/E
Configuration and Setup
PREPARING FOR GA-1310 SETUP
Connecting network cable to the GA-1310
REFERENCE for GA-1310/E
Configuration and Setup
SETTING UP THE GA-1310 FROM THE COPIER TOUCH PANEL
Network Setup options
TCP/IP Setup options
IPv4 (TCP/IP) Setup
REFERENCE for GA-1310/E
Configuration and Setup
SETTING UP THE GA-1310 FROM THE COPIER TOUCH PANEL
Services Options
Windows Setup (SMB) Options
REFERENCE
 P.23 “Installing the Printer Driver for SMB Printing”
REFERENCE
 P.43 “Configuring the Option”