Installing the Printer Driver 23
Installing the Printer Driver
Installing the Printer Driver for SMB Printing
The following describes an installation on Windows Vista. The procedure is the same when
other versions of Windows are used.
When you are using Window Vista, proceed to the next step.
When you are using Windows operating system other than Windows Vista, proceed
to step 4.
PREPARATIONS:
Before installing the printer driver to use SMB printing, please make sure of the following:
If a previous version of the printer driver has been installed on the system, it must be removed. (For
instructions on how to remove the printer driver, refer to the Printing from Windows.)
The GA-1310/E printer is connected to the network and turned on.
The TCP/IP setting is completed correctly.
The Windows Printing is completed correctly.
1
Open the GA-1310/E printer in
the network with Windows
Explorer, and double-click a
queue in which the printer
driver should be installed.
print - print jobs are spooled to the
hard disk in the GA-1310/E printer
and printed out. Use this queue for
general printing.
direct - print jobs are sent straight to
the printer without spooling.
hold - print jobs are held until users
operate copying or moving them to
the Print queue with the job manage-
ment tools.
You cannot change the order of print
jobs by moving them, which are sent to
the direct queue.
2
The Printers dialog box asking
you to install the printer driver
is displayed. Click [Install
driver].
The User Account Control dialog box
appears.
To Next Page
Loading...
