Kyocera TASKalfa 650c

Setup Flow for Windows 13
For IPP Printing
 Connecting the GA-1310/E
Connect the GA-1310/E to your network with a network cable.
 Setting up TCP/IP
Configure the TCP/IP Setup options to assign the IP Address, Subnet Mask, and Gateway
Address on the GA-1310/E to enable Fiery WebSetup from the control panel.
 Setting up the Printing Service
Configure the IPP Printing to enable the IPP Printing Service from Fiery WebSetup or Command
WorkStation.
 Installing the Printer Driver
Install the printer driver to use IPP printing.
 Configuring the Options
Configure the option settings on the printer driver.
REFERENCE for GA-1310/E
Configuration and Setup
PREPARING FOR GA-1310 SETUP
Connecting network cable to the GA-1310
REFERENCE for GA-1310/E
Configuration and Setup
SETTING UP THE GA-1310 FROM THE COPIER TOUCH PANEL
Network Setup options
TCP/IP Setup options
IPv4 (TCP/IP) Setup
REFERENCE for GA-1310/E
Configuration and Setup
SETTING UP THE GA-1310 FROM THE COPIER TOUCH PANEL
Services Options
Web Services Setup
REFERENCE
 P.33 “Installing the Printer Driver for IPP Printing”
REFERENCE
 P.43 “Configuring the Option”