Kyocera TASKalfa 650c

2 INSTALLING THE PRINTER DRIVER (Windows)
40 Installing the Printer Driver
1
Open the NetWare server
(when using in bindery mode)
or NDS directory tree (when
using in NDS or NDPS mode)
in the Network Neighborhood
with the Windows Explorer,
and double-click a queue.
 Select a queue depending on how
you want to print.
[given name]_print - print jobs are
spooled to the hard disk in the GA-
1310/E printer and printed out. Use
this queue for general printing.
[given name]_direct - print jobs are
sent straight to the printer without
spooling.
[given name]_hold - print jobs are
held until users operate copying or
moving them to the Print queue with
the job management tools.
 When using the NetWare 5.x in
NDPS mode and the printer drivers
for each Operating System are
installed to a NDPS broker, the
printer driver is automatically
installed.
 Unless using the NetWare 5.x in
NDPS mode and printer drivers for
each Operating System are installed
to a NDPS broker, the Add Printer
Wizard dialog box appears. Continue
to the next step.
You cannot change the order of print
jobs by moving them, which are sent to
the direct queue.
The queue names created on the NetWare server should be either “[given name]_print”,
“[given name]_direct”, “[given name]_hold” ([given name] can be any name). Those queues
correspond to the GA-1310/E printer’s queues, Print, Direct, and Hold.
2
Click [OK].
The Add Printer Wizard dialog box
appears.