Kyocera TASKalfa MA3500ci - Page 108

5-23
Using Convenient Fax Functions > Polling Communication
Using Polling Reception
1
Select [Fax] on the Home screen.
2
Turn on polling reception.
[Advanced Setup] > [Fax Polling RX] > [On]
3
Specifying destination.
For the procedure for selecting a destination, refer to the following:
4
Press the [Start] key.
The operations for reception begin.
Using Polling Reception with Sub Addresses
For polling reception, enter the sub address (on this machine, sub address and sub address password) set at the
sending machine. This communication is still possible when the other party is using a third-party machine
provided it is equipped with the same type of sub address communication function.
1
Select [Fax] on the Home screen.
2
Turn on polling reception.
To turn on polling reception, refer to the following:
3
Select the destination, and entering the sub address.
For the procedure for setting a sub address, refer to the following:
For the procedure for selecting a destination, refer to the following:
NOTE
When the other party is using sub addresses, refer to Using Polling Reception with Sub
Addresses below.
Methods For Entering the Destination (page 3-7)
NOTE
When [On] is selected in [Dest. Check before Send], a destination confirmation screen
is displayed when you press the [Start] key.
Confirmation Screen of Destinations (page 7-13)
IMPORTANT
Check the sub address set by the sender beforehand.
Polling Reception (page 5-22)
Sub Address Transmission (page 5-16)
Methods For Entering the Destination (page 3-7)
NOTE
You can select destinations using a combination of numeric keys input, One Touch Key
selection and selection from the Address Book containing registered sub addresses.