Kyocera TASKalfa MA3500ci - Indicators During Sending;Receiving Operation; Responding to an Attention Indicator Flashes

9-2
Troubleshooting > Indicators During Sending/Receiving Operation
Indicators During Sending/Receiving Operation
The [Data] indicators show the fax transmission status.
•The [Data] indicator blinks during fax transmission and reception.
•The [Data] indicator is lit when there is source data stored in the memory for delayed transmission.
Responding to an Attention Indicator Flashes
If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message
is not indicated on the touch panel when the [Status/Job Cancel] key is pressed or the [Attention] indicator
flashes, check the following.
Symptom Checkpoints Corrective Actions
Reference
Page
Cannot send fax. Is the modular cord
connected correctly?
Connect the modular cord
correctly.
—
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Check Permitted FAX No. and
Permitted ID No.
8-17
Has a communication error
occurred?
Check error codes in the TX/RX
Result Report and Activity Report.
If the error code starts with "U" or
"E", perform the corresponding
procedure.
9-6
Is the destination FAX line
busy?
Send again. —
Does the destination FAX
machine respond?
Send again. —
Is there an error other than
above?
Contact your Service
Representative.
—
Stop
System Menu
Counter
Start
F1
F2
F3
Copy
Send
FAX