8-27
Fax Settings > Account Management
Communication modes subject to job accounting
• Normal transmission
• Delayed transmission
• Broadcast transmission
• Sub address transmission
•Encrypted transmission
• Manual send when dialed from this machine to the receiving system
• Polling reception
• Sending Faxes from PC (Destinations include FAX.)
• Transmission from the document box
Restriction of use function
When you have enabled job accounting, you need to enter an Account ID when
performing the following operations.
• Normal transmission
• Delayed transmission
• Broadcast transmission
• Sub address transmission
• Output from Subaddress Box
•Encrypted transmission
• Manual send when dialed from this machine to the receiving system
• Polling reception
• Sending Faxes from PC (Destinations include FAX.)
• Transmission from the document box
When job accounting has been enabled, batch transmission function works only for
communication to be performed for the same Account ID. The communication to be
performed with a different Account ID is not conducted as a batch transmission.
Normally, the Local FAX Name is printed in the transmit terminal identification (TTI).
However, when job accounting is enabled and an Account ID is entered when a fax is
sent, you can enable a setting to have the Account Name or Local FAX Name, whichever
was selected, be printed.
You can use ‘Make a call’, ‘Checking FAX Job History’ and ‘Communication Control
Report Output’ functions without entering an Account ID or Administrator No.
Account as Local Fax Name (page 8-9)
To Next Page
Loading...
