EasyManua.ls Logo

KZ DURANGO - Fifth Wheel Hook up

KZ DURANGO
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
2. Release the safety latch on the coupler.
3. Raise the coupler on the A-frame by turning the tongue jack until
the ball is free.
4. Disconnect the 7-way wire connector, safety chains, and the
breakaway cable.
5. Raise front jacks until Tow vehicle will clear coach. Drive Tow
vehicle away.
6. Now raise/lower front end until coach is level.
7. Lower stabilizer jacks to desired position to stabilize coach.
8. Reverse procedure to hook up coach to tow vehicle.
Fifth Wheel Hook Up
1. Extend lower leg extensions to solid support and insert pin fully.
2. Lower front jack extensions with “crank or 12 volt D.C. power,
placing some weight onto support.
3. Unlatch fifth wheel connection.
4. Disconnect 7-way connector and break-away cable.
5. Raise front jacks until tow vehicle will clear coach. Drive tow
vehicle away.
6. Now raise / lower front end until coach level.
7. Lower stabilizer jacks to desired position to stabilize coach.
8. Reverse procedure to hook up coach to tow vehicle.
The use of stabilizer jacks on a recreational vehicle is a popular and
useful option. They provide a reasonable amount of stability while
using, occupying, and moving around in your camper. It is important
to remember that stabilizer jacks are for support of the coach and
are not designed to bear the weight of a recreational vehicle.
To operate the stabilizer jack, place crank onto the jack shaft and
turn clockwise to lower until the frame begins to raise slightly.
Equalize all four jacks for best support. You may need to adjust
each jack two or three times.
To raise jack to upper travel position, insert crank and turn
counterclockwise until jack is seated in UP travel position.
Upon completing the setup of your coach, you are now ready to
make attachments to various facilities:
v Waste water hose connections.
v 110-Volt power cord electrical hookup.
v Turn on propane tanks and light pilot lights, if any, on
appliances. Remember there may be air in your propane lines.
Be sure to bleed them before planned usage.
PDF created with pdfFactory trial version www.pdffactory.com

Table of Contents

Related product manuals