88
“M” (example SR3SABM; SC3AM) hold a long match near
the burner ports.
If your model ends with “E” (example SR3SABE; SC3AE) the
burner can be lit by rotating the piezo knob clockwise rapidly.
This produces a spark at the burner which ignites the propane.
3. If any burner should extinguish after initial lighting or due to
accidental blow out, turn propane off by turning control knob
clockwise to “OFF”. Wait five minutes before attempting to
relight the burner. Failure to follow these instructions could
result in a fire or explosion.
If the burner should go out while cooking, or if there is an odor of
propane, turn the control knob(s) clockwise to “OFF”. Wait five
minutes for the propane odor to disappear. If the propane odor
is still present – DO NOT relight the burners. See instructions in
the appliance manual.
4. To turn the burner(s) off, turn the appropriate control knob
clockwise to “OFF”.
Oven Burner
Note: Before the oven burner will operate, the oven pilot must be lit.
1. Lighting Oven Pilot
a. Be sure ALL valves are in the “OFF” position. The oven
control knob should be in the “Off” position.
b. Be sure main propane supply is on.
c. Open the oven door; smell for propane. If you smell
propane, STOP! Read and follow the instructions in your
appliance manual.
d. If you do not smell propane, turn knob to the pilot position.
“ Push In/Lite Pilot”.
e. Immediately light pilot with a match. Hold knob in at least 5
to 7 seconds, for this allows propane to flow to pilot and to
ALL PILOT LIGHTS, APPLIANCES AND THEIR IGNITORS (SEE OPERATING IN-
STRUCTIONS) SHALL BE TURNED OFF BEFORE REFUELING OF MOTOR FUEL
TANKS AND/OR POPANE CONTAINERS. FAILURE TO COMPLY COULD RESULT
IN DEATH OR SERIOUS INJURY.
DANGER
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
