44
CLOSE : To retract, reverse the procedure and hold button until the
room is fully inside with gaskets sealing to the outer wall. It takes
about 20 seconds to move the slide in or out.
KZRV does NOT require or suggest blocking, supports, jacks, etc.,
to be used under slide outs during extended normal use.
Electrical Components
A 12 volt DC motor is
located under the frame. It
may be inside of main rail
on frame, or on some
models it will be on the
outer side on main rail along
with front to rear shaft. On
the above floor slide, it will
be under the floor of the
sofa or dinette.
Operational switch: This switch, is a three position, (off center, in or
out) spring loaded switch. Select which direction you wish to move
the room. Press on desired position and hold until room is seated,
and gasket is slightly compressed. Do not force the room to move
beyond sealing as damage
could occur.
MANUAL OVERRIDE:
Should a power failure occur (no 120 volt AC power or the battery
looses its charge), follow the directions listed below:
1. On Lippert rack and pinion frames, there is a 1/2” shaft coming
through the main rail of frame. On the outer end is a small,
1/8”x1 1/2” pin that goes through the shaft. Use an adapter,
plus socket, and ratchet to move slide in or out. Some use 3/4”
nut welded to shaft rather than pin.
2. On DVS there is a 1/2” shaft coming through the frame rail. On
the end is a 3/4” nut attached to the shaft. Use a 3/4” socket
extension and ratchet to move the slide.
ABOVE FLOOR SLIDE-OUT
Manual Override (Single or Double Rams)
Should 12 volt power fail and there is no 120 volt AC power
available, follow the directions listed.
IN
OUT
5_________
4_________
3_________
2_________
1_________
Green power to motor-in
White ground
Red power to master switch
and 15 amp break
White ground
Black power to motor-out
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
