58
FLUSH SYSYTEM
The flush system is designed and built to rinse the waste holding tank,
AFTER waste tank has been drained completely of water and solids.
1. Attach a fresh water source to the connection marked “Sewer Tank
Flusher”. Be sure termination valves are open on tanks.
2. Open valve to release water into tank for rinsing and cleaning of
your waste water holding tank.
3. Rinse for several minutes to remove any foreign matter from tank,
and probes.
Remember the moisture content may give you a false reading on your
monitor panel indicating it is full. Allow time to dry out tank or recharge
for next usage.
Maintenance for Holding Tanks
The following maintenance is recommended by our holding tank
suppliers to keep your tanks clean and keep the probes free of debris
and build-up.
Gray (Waste-Water) Tank. Fill tank with 8-10 gallons of warm water.
Add a degreaser such as a citrus cleaner or Dawn dish soap. Leave
solution in tank while you are traveling. Rinse and drain tank.
Black (Sewer) Tank. Fill tank with 8-10 gallons of water. Add one
bottle of drain cleaner, such as Drano or Liquid Plumber. Leave the
solution in tank while traveling. Rinse and drain tank.
Heated Holding Tanks
Optional heated holding tanks are available on many models. Two (2)
methods used to distribute heat are: (1) Placing holes from tank
compartment into heat duct built into floor, allowing warm airflow
throughout tank area, (2) Heating pads attached to tank with adhesive,
operated with 12V power from battery and/or converter. The lighted
switch to turn on the pads is normally located in bathroom area.
Sewer Tank Flusher– Sewer valves must be OPEN when using this inlet.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
