LaneShark LS-3 - ADJUSTMENTS; TRANSITION PROCESS

(850) 610-2870 www.lanesharkusa.com 29
Lane Shark LS-3ADJUSTMENTS
Transition Process
Your Lane Shark is capable of cutting in 11 dierent positions.
Once you have successfully connected the Lane Shark to your tractor and
familiarized yourself with all of its components, it is time to begin learning
the transition process. This section will go over how to properly transition
your Lane Shark into each of those positions.
Before you get started make sure:
• Tractor gear selector is in park or set park brake.
• Engine is o.
• Ignition key is removed.
• Tractor is parked on a level surface.
• All hydraulic hoses are disconnected from the Lane Shark.
Positions
1. Home (Directly in front) [A]
2. Oset (0 degrees level) [B]
3. Oset (25 degrees lowered)
4. Oset (35 degrees lowered) [C]
5. Oset (25 degrees raised)
6. Oset (35 degrees raised)
7. Vertical (90 degrees upright) [D]
8. Vertical (25 degrees lowered)
9. Vertical (35 degrees lowered) [E]
10. Vertical (25 degrees raised)
11. Vertical (35 degrees raised)
A
C
B
D
E
Position Change
Safety Video
Scan with Smart Phone