(850) 610-2870 www.lanesharkusa.com 8
Lane Shark LS-3
INTRODUCTION
GENERAL INFORMATION
APPLICATION
• The Lane Shark LS-3 is a light duty rotary cutter designed to clear
overgrown roadways, for light land management, and property
maintenance.
• The LS-3 will easily cut up to 2-3” diameter limbs, brush, saplings,
and underbrush. The Lane Shark has 11 positions that allow it to cut
vertically, Oset, directly in front (level), or 25°, 35°, & 45° in the vertical
and oset positions.
• The Lane Shark LS-3 attaches to the front of any FEL tractor with a
SSQA or JD Hook & Pin-Style attachment system. There are adapters
available to t most other applications sold separately.
• The Lane Shark LS-3 weighs just under 320 lbs.
• In order for the Lane Shark brush cutter to operate to full potential, the
tractor must have a hydraulic ow rate of at least 5 GPM.
• To run the Lane Shark, you must have rear remotes or third function.
ONLY Pressure comes from the remote, and return must be to the
sump. (CANNOT RETURN THROUGH AUXILIARY HYDRAULICS)
• When purchasing the Lane Shark brush cutter, you will receive a
unit equipped with #8 ORB (O-ring Boss) inlets. When using ORB, a
minimum inside diameter of 3/8” is required.
• NOT COMPATIBLE WITH DIVERTER VALVES
To Next Page
Loading...