Lantronix EDS32PR - A: Factory Default Configuration; Default Network and Serial Settings

EDS Device Servers User Guide 143
A: Factory Default Configuration
This appendix lists the EDS factory-default configuration. The types of settings are in
alphabetical order.
Network Configuration Settings
Network Configuration
Parameters
Network Configuration Settings
BOOTP Client Off (disabled)
DHCP Client On (enabled)
IP Address 0.0.0.0 (auto-IP if DHCP fails)
Network Mask 0.0.0.0 (auto if DHCP fails)
Gateway 0.0.0.0
MAC Address Specified by manufacturer
Hostname None
Domain None
DHCP Client ID None
Ethernet Auto speed, auto duplex
Serial Port Line Settings
Serial Port Line
Parameters
Serial Port Line Settings
Status Enabled
Protocol Tunnel
Baud Rate 9600 baud
Parity None
Data Bits 8