A: Factory Default Configuration
EDS Device Servers User Guide 145
Start/Stop Characters
Start/Stop Character
Parameters
Start/Stop Character Settings
Start Character None
Stop Character None
Echo Start Character Off
Echo Stop Character Off
Accept Mode
Accept Mode Parameters Accept Mode Settings
Accept Mode Enabled
Local Port Port 1 = 10001, Port 2 = 10002, Port 3 = 10003,
and so forth. (For line x, the local port is 10000+x.)
Protocol TCP
Flush Serial Data Disabled
Block Serial Data Off
Block Network Data Off
TCP Keep Alives 45 seconds
Email on Connect None
Email on Disconnect None
Password None
Prompt for Password Off
Connect Mode
Connect Mode Parameters Connect Mode Settings
Connect Mode Disabled
Remote Address None
Remote Port None
Local Port Random
To Next Page
Loading...
