7: Network, Line, Tunnel, and Terminal Settings
EDS Device Servers User Guide 75
Login Connect Menu
An administrator can set up a menu on the EDS for terminal users.
For a terminal attached to serial Line N, set as follows:
Line[N] Protocol = None
Line[N] Command Mode = Always
Terminal[Line N] Login Connect Menu = Enabled.
For Telnet-attached terminals, set:
Terminal [Network] Login Connect Menu = Enabled.
The terminal user will see a menu roughly like this:
Password :
Connection menu: (select by number)
1) Alpha 2) Beta
3) Exit to command line interface 4) Log out
Selection =
The administrator adds destination serial line M to the menu by filling in Line[M] Name.
For this purpose, set:
Line[M] Protocol = None
Line[M] Command Mode = Disabled.
The administrator adds a network destination to the menu by setting up a Host entry for
it. Each named Host entry will appear in the menu.
The administrator adds the Exit to command line interface choice to the menu by
setting:
Terminal[Line N] or Terminal[Network] Exit Connect Menu = Enabled.
The Log out choice is always present.
To Next Page
Loading...
