Troubleshooting BCP Command Examples
B-6
Change Software filename
Specifies the name of the file to load. The MSS will automatically add .SYS to the filename you
specify. Note that all protocols must have a filename specified (either the default or set by the user).
For more information, see
Appendix D.
TCP/IP users must use the Software option to specify the loadhost, the loadfile, and their own
network address.
TFTP users can specify a complete path name (up to 31 characters) if the file is located in a directory
other than the default.The case of the filename must match that of the filename loaded onto the host
computer.
Show Server
Use this command when issuing other commands to view the current MSS setup.
To Next Page
Loading...
