Lars Thrane LT-3100 - Page 37

LT-3100 User & Installation Manual Rev. 1.06 Installation and Mounting
Lars Thrane A/S www.thrane.eu Page 26 of 155
NOTE: The Pole Mount (2.0” pipe, Ø53.0mm), Antenna Unit only supports a 2.0” pipe. The pinot
screws (antenna and pole lock) torques are specified in Figure 29 and Figure 30. The pole
mount is made of milled aluminum (anodized). The pinot screws are made of A4 stainless
steel.
Figure 29: Pole Mount (2.0” pipe, Ø53.0
mm), Antenna Unit.
Figure 30: Pole Mount (2.0” pipe, Ø53.0 mm),
Antenna Unit.