2 7
a t t e n d a n t ' s p l a c e
a t t e n d a n t ' s p l a c e
- Set the switch key in the START position. Having the engine started
release the key.
- Reduce the engine speed and let the engine running.
- If the engine runs regularly, turn on the chipping device by a lever for belts
tightening. Increase the engine idling speed.
- valid only for LS 150 DW: while starting the engine the breaker starts
turning simultaneously – this transmission of power cannot be interrupted!!
- Having turned the chipping device on wait for speed stabilization. With that
you may soever increase or reduce the speed.
- CAUTION!!! As soon as the chipping device is ON then the chips
from previous operation may be ejected from the discharge duct.
- Carry out functional checks of the safety frame of the loading chute. Set
the lever in the in-feed position and the loading rolls start turning (loading).
By first pushing the frame the rolls should stop loading immediately
(EMERGENCY STOP), the next pushing behind the chute edge (D) brings
their reverse turning.
To Next Page
Loading...
