April 8, 2011 HN FAQ Memo, Version 3.0 Page 22 of 108
Press 2 for multivalve.
Move curser to “lift arm” and press enter to change to “On”.
Move curser to “Arm position” and pres enter and change position by entering the number of the new
position, (pos. 16 is a position easy to se on the other side of the multivalve)
Press enter and the arm will move to the new position, and be lifted after moving.
Check the centering of arm related to the stud on different positions on the range of the multivalve.
Set “lift arm” to off before leaving the menu.
Note: if the arm is not centered on all studs move back to the adjustment chapter and correct the
adjustment..
Note: that there are different types of MV lids, one with 28 studs and one with 32 studs. In the settings
menu (menu 231) the MV type has to be selected to the correct one.
28 studs= (2x14) and 32 studs = (2x16).
If this setting is wrong the distance between the multivalve positions will not match the distance between
the studs on the multivalve lid.
To Next Page
Loading...