X-431 EURO TAB II User Manual
30
Fig. 5-10
If the VIN scanned is incorrect, tap the result field to modify it and then tap
“OK”. If the VIN exists on the remote server, the system will enter the vehicle
information screen.
To scan it again, tap “REPEAT”.
INPUT VIN: In this mode, you need to input the VIN manually. In general, vehicle
identification numbers are standardized - all contain 17 characters. VIN
characters may be capital letters A through Z and numbers 1 through 0; however,
the letters I, O and Q are never used in order to avoid mistakes of misreading.
No signs or spaces are allowed in the VIN.
Tap “INPUT VIN”, input the VIN and tap “Confirm”. The system will automatically
identify the vehicle model and directly navigate to the function selection page.
Fig. 5-11
B) Manual Selection
Tap a corresponding diagnostic software logo, and then follow the on-screen
(c) Launch & Diagtools. Tel. +37167704152, +37129416069. www.diagtools.lv
To Next Page
Loading...
