Safety & Accessory
Initial UseDiagnosticsFAQ & Care
Product Prole
15
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
4.3.3 Vehicle Connection
through a standardized DLC.
connection, and in some cases supplies 12V power through the cigarette lighter receptacle or a
connection to the vehicle battery.
SmartLink C device To Vehicle's DLC port
, proceed as follows:
SmartLink C device
To Vehicle's DLC port
Non-16pin connector
Notes:
If the power supply on vehicle diagnosc socket is insucient or the power pin is damaged, you can get power via
either of the following ways:
A. Via Baery clamps cable (oponal): Connect one end of the baery clamps cable to the power jack of the OBD I
adaptor box, and the other end to the vehicle’s baery.
SmartLink C device OBD II extension cable
To Vehicle's DLC port
To Cigarette lighter
receptacle
OBD I adaptor
Non-16pin connector
Cigarette lighter cable
B. Via Cigaree lighter cable (oponal): Connect one end of the cigaree lighter cable to the power jack of the OBD
I adaptor box, and the other end to the cigaree lighter receptacle.
SmartLink C device OBD II extension cable
To Vehicle's DLC port
To vehicle's battery
OBD I adaptor
Non-16pin connector
Battery clamps cable
4.4 Communication Setup
There are 3 kinds of ways available for the tablet to communicate with the SmartLink C device: Wi-Fi,
After the sign-up is successfully completed, the Wi-Fi communication between the tablet and the SmartLink
To Next Page
Loading...
