Safety & Accessory
Initial Use
Diagnostics
FAQ & Care
Product Prole
34
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
2. After changing engine oil or electric appliances that monitor oil life, you need to reset the service lamp.
6.2 Electronic Parking Brake Reset
the on-board computer to replace the brake pad. After replacing the brake pad, you must reset the brake
pad. Otherwise, the car alarms.
2. Reset must be performed in the following cases:
6.3 Steering Angle Calibration
this position as reference, the ECU can calculate the accurate angle for left and right steering.
After replacing the steering angle position sensor, replacing steering mechanical parts (such as steering
body, you must reset the steering angle.
6.4 ABS Bleeding
This function allows you to perform various bi-directional tests to check the operating conditions of Anti-lock
6.5 Tire Pressure Monitor System Reset
TPMS replacement and sensor test.
2. Tire pressure resetting must be performed after maintenance is performed in the following cases: tire
pressure is too low, tire leaks, tire pressure monitoring device is replaced or installed, tire is replaced, tire
pressure sensor is damaged, and tire is replaced for the car with tire pressure monitoring function.
6.6 Gear Learning
The crankshaft position sensor learns crankshaft tooth machining tolerance and saves to the computer to
6.7 IMMO Service
ignition key or other device is present. Most new vehicles have an immobilizer as standard equipment. An
audible alarm alone.
To Next Page
Loading...
