FAA APPROVED 4-30-76 4-9
REISSUED 2-25-81, CHANGE 14
SINGLE GENERATOR FAILURE
1. Electrical Load — Reduce.
a. COOL-FAN-OFF Switch — OFF.
b. Shed other loads as required to observe generator limits.
2. IGN & ST Circuit Breaker (main power bus) — Check and reset.
3. START-GEN Switch — GEN.
START-GEN switch must be set to GEN for GEN
RESET switch to be effective.
4. GEN RESET Switch — Depress momentarily.
Depressing and holding the GEN RESET switch longer
than one-half second, or multiple activations, may cause
damage to the electrical system.
If Generator Does Not Reset:
5. Turbine Speed (N
2) — 80% or greater.
6. START-GEN Switch — OFF, then GEN.
7. GEN RESET Switch — Depress momentarily.
If Generator Does Not Reset:
8. START-GEN Switch — OFF.
NOTE
CAUTION
FAA APPROVED 4-30-76 4-9
REISSUED 2-25-81, CHANGE 14
SINGLE GENERATOR FAILURE
1. Electrical Load — Reduce.
a. COOL-FAN-OFF Switch — OFF.
b. Shed other loads as required to observe generator limits.
2. IGN & ST Circuit Breaker (main power bus) — Check and reset.
3. START-GEN Switch — GEN.
START-GEN switch must be set to GEN for GEN
RESET switch to be effective.
4. GEN RESET Switch — Depress momentarily.
Depressing and holding the GEN RESET switch longer
than one-half second, or multiple activations, may cause
damage to the electrical system.
If Generator Does Not Reset:
5. Turbine Speed (N
2) — 80% or greater.
6. START-GEN Switch — OFF, then GEN.
7. GEN RESET Switch — Depress momentarily.
If Generator Does Not Reset:
8. START-GEN Switch — OFF.
NOTE
CAUTION
To Next Page
Loading...
