14–12
CURSORS/MEASURE & Parameters
SETUP “∆c2d+” — for customizing the ∆c2d+ parameter.
hysteresis
To set the hysteresis division. Hysteresis essentially enables the
user to set a voltage band, which a waveform peak–trough pair
must exceed in order not be considered either noise or a “bump”.
This threshold crossing is recognized when an acquisition point in
the waveform passes through the threshold level by 1/2 the
hysteresis-division setting.
clock edge
To select the clock edge or edges used for this parameter
measurement.
data edge
For selecting the data edge or edges used for the measurement.
To Next Page
Loading...
