System Commands
DISPLAY
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
Response format
EXAMPLE (GPIB)
RELATED COMMANDS
MULTI_ZOOM, MZOM
Command/Query
By setting MULTI ZOOM ON, the horizontal magnification and
positioning controls apply to all expanded traces simultaneously.
This command is useful if the contents of all expanded traces are
to be examined at the same time.
The MULTI_ZOOM? query indicates whether multiple zoom is
enabled or not.
Note: This command has the same effect as DUAL_ZOOM.
Multi_ZOoM <mode>
<mode> := {ON, OFF}
Multi_ZOoM?
Multi_ZOoM <mode>
The following example turns the multiple zoom on.
CMD$--"MZOM ON": CALL IBWRT(SCOPE%,CMD$)
HOR_MAGNIFY, HOR_POSITION, DUAL_ZOOM, ZOOM
108
To Next Page
Loading...
