PRE START-UP INSPECTION
GENERAL OPERATION
To assure that the tack distributor provides the best possible service before use, a pre-
start up inspection should be performed.
1. Engine
(A) Check oil level.
(B) Check fuel tank level.
(C) Check for any cracked, broken or worn parts.
2. Tack Tank and Attaching Components
(A) Check tack level, fill if needed.
(B) Remove contamination on surface.
(C) Check spray wand valve to make sure it works freely.
(D) Check propane level.
(E) Check flow valves to make sure they are working freely.
(F) Check flush tank level.
(G) Check for cracked, broken or worn parts.
(H) Check wheel lugs.
(I) Check tire pressure.
START-UP
GENERAL OPERATION
An engine manual is provided with the tack distributor and should be used whenever start-
ing, operating, and servicing engine.
TACK DISTRIBUTOR
17
TACK DISTRIBUTOR
TURN FLUSH VALVE ON
BEFORE STARTING ENGINE
To Next Page
Loading...
