TACK DISTRIBUTOR
6
TACK DISTRIBUTOR
WARNINGS
ALL WARNING DECALS MUST BE FOLLOWED. IF YOU DO NOT FOLLOW THE INSTRUCTIONS, ANY
MISTAKE YOU MAKE COULD RESULT IN SERIOUS INJURY AND/OR PHYSICAL HARM TO YOU OR
OTHERS. DAMAGE TO THE MACHINE IS ALSO POSSIBLE.
• NEVER DO ANY MAINTENANCE WHILE
BURNERS ARE ON OR ENGINE IS RUNNING.
• NEVER LIGHT TACK BURNERS WITH
ANYTHING BUT LIGHTER PROVIDED.
• NEVER USE SEAL COATING UNLESS FIRST
CONTACTING DISTRIBUTOR FOR CORRECT
SPECIFICATIONS. NEVER USE FIBER BASE
SEAL COAT; THIS COULD DAMAGE THE PUMP
AND CLOG THE SPRAY WAND.
• ALWAYS MAINTAIN TACK LEVEL AT LEAST 3
INCHES ABOVE BURNER FLUE.
• NEVER EXCEED TOWING SPEED SET BY
CITY, STATE, AND FEDERAL LAWS. FURTHER-
MORE, USE LOWER SPEED WHEN TOWING
OVER SLIPPERY OR UNEVEN SURFACES.
•
NEVER ALLOW EXCESSIVE TACK TO BUILD
UP ON
TACK TANK. THE TACK MAY BE
A
CCIDENTALLY IGNITED.
•
NEVER FILL FUEL
T
ANK OR TACK WHILE
ENGINE IS R
UNNING OR PR
OP
ANE
B
URNERS ARE LIGHTED
.
• ALWAYS SCOTCH/CHOCK TACK DISTRIBUTOR
WHEN LEFT UNATTENDED.
• ALWAYS BE EXTREMELY CAREFUL WHEN
IGNITING BURNERS WITH THE LIGHTER
PROVIDED. MAKE SURE THE LIGHTER IS KEPT
AWAY FROM THE FUEL TANK AND OTHER
FLAMMABLE MATERIAL.
• ALWAYS MAINTAIN DECALS ON MACHINE
AND REPLACE IF MISSING OR BADLY WORN.
• ALWAYS KEEP ALL UNAUTHORIZED
PERSONNEL AWAY FROM WORKING TACK
DISTRIBUTOR. ANY AUTHORIZED PERSONS
SHOULD WEAR PROTECTIVE CLOTHING AND
GLASSES.
• ALWAYS USE A VEHICLE OF ADEQUATE SIZE
WHEN TOWING A TACK DISTRIBUTOR.
Q
UICK STOPS MAY NOT BE POSSIBLE
WHEN USING AN UNDERSIZED
TOWING
VEHICLE.
• NEVER LEA
VE
T
ACK DISTRIBUTOR
UNA
TTENDED
WHILE HEA
TING.
• NEVER REMOVE SPRAY WAND NOZZLE
WHILE ENGINE IS RUNNING.
To Next Page
Loading...
