LEGRAND Tynetec Advent XT2 - ACTIVITY MONITORING PROGRAMMING (CONTINUED); Setting Activity Monitoring Days; Viewing All Activity Monitoring Settings

Doc No. FM0814 issue 5 Page 21
18. ADVENT XT2 PROGRAMMING
The PBX Ring Type must be enabled in the Advent XT2 system programming;
ADVENT XT2 PROGRAMMING
Enter programming mode on the Advent XT2 controller and go to the Onsite & General Setup page.
Set the PBX Ring Type Enable  check box, press the green  button then Apply the change.
Refer to the Advent XT2 programming manual Doc No. FM0815 for more information.