Doc No. FM0814 issue 5 Page 4
Read and understand these instructions before use. Refer to the Manufacturers installation and user
guides for more information (see section 6 of this manual). Keep all instructions for future reference.
Take care when working on step ladders during installation or service.
Isolate the mains supply before removing covers.
Do not disassemble any part of the system or attempt to repair it yourself.
No user serviceable parts inside. Refer all servicing to qualified service personnel.
PSU’s should only be connected to a 220-240VAC 50/60Hz mains supply. If you are unsure of the type
of power supply consult your local power company.
Danger of explosion if rechargeable batteries are incorrectly replaced. Use only Manufacturer
approved batteries as specified in this manual.
Only use Manufacturer approved cable during installation. See section 7 of this manual for details of
cable type, recommended colour code and cable length restrictions.
DECT products should be located at least 5 metres away from any other electronic equipment.
Failure to provide this separation may result in reduced radio range.
Do not locate DECT products above a radiator or other heat source.
Do not expose DECT products to direct sunlight.
Do not submerge DECT products in water and do not use in damp or humid conditions.
Do not drop or expose DECT products to high vibration or shock.
Do not expose DECT products to dripping or splashing water.
Liquids can cause a failure and/or a fire hazard.
Clean DECT products with a damp cloth and a non-abrasive cleaning product. Polish with a dry
duster. DO NOT use a wet cloth.
Avoid using harsh, abrasive, or corrosive cleaning agents or detergents (e.g. scouring powders,
bleaches, polishes, etc.) when cleaning DECT products.
At their end of life DECT products should be disposed of and recycled in accordance with the
environmental regulations. See the Regulatory Information in section 3 of this manual.
To Next Page
Loading...
Need help?
General
