Leibinger JET2 neo - Page 44

Page 42 Transport/Start up Group 5
Release R1.07 en JET2 neo
 Turn on the printer. For this touch the dark touch-display (1) at any position for
approx. 2 sec.

The device turns on and the message<Initialization>
(2) is displayed. Wait until
the initialization is finished. After this process the
message <Emergency
Shutdown> (3) is displayed.

Press the button <OK (3
3
)> (4).

Go to the “Special functions”
area by clicking on the appropriate register card
(5).

Now press the button <Fill up Routine> (6). The message <Fill up Routine>
(7) is faded-in.

Press the button <Next> (8) to start the filling routine.
Note: This process takes approx. 10 minutes.

After finishing the process an according message (9) is displayed. Press the
button <OK> (10) to finish the routine.

Press the <Close> button (11) to exit the <Special functions> area.

The message <Hydraulic control> (12) is faded-in.
Note:
For leaving the service menu the hydraulic control will be turned on again
automatically.

Press the button <OK (
3
) > (13) to close the service menu.

If required the device starts automatically with the bleeding of the system.
During the process the message <Bleeding>
(14) is displayed. The bleeding
takes between 1–
5 min. The process can be canceled by pressing the button
<Cancel> (15).
 The basic menu (16) is now displayed and the printer is ready to operate.