Leica TM30 Series User Manual

Application Programs - Getting
Started
TPS1200+/TS30/TM30 7
1 Application Programs - Getting Started
1.1 Starting an Application Program
Access
an application
program
step-by-step
XX Begin SURVEY Survey Begin is shown as an example. Additional fields are available for
particular application programs.
Description of fields
Step Description
1. PROG. The PROG key opens the TPS1200+ Programs menu.
2. Select an application program from the menu.
3. Press CONT (F1) to access a Begin screen.
)
Some application programs are protected. They are activated through a
specific licence key. This can either be typed in Main Menu:
Tools...\Licence Keys or the first time the application program is started.
)
Four application programs can be open at one time. XX Begin is shown
for the application program opened first, but not for the following applica-
tion programs.
CONT (F1)
To accept changes and access the
subsequent screen.
CONF (F2)
To configure the application program.
SETUP (F3)
To set up the station.
CSYS (F6)
To select a different coordinate
system. Not available for <Use Auto
CrdSys: Yes> configured in CONG-
FIGURE Additional Rover
Settings.
Field Option Description
<Stakeout Job:> Choicelist • Available for Stakeout.
• The job containing the points to be
staked.
<Fixpoint Job:> Choicelist • Available for Traverse.
• The job containing points for the
control points, to begin, to check and
to end the traverse.

Leica TM30 Series Specifications

General

Brand	Leica
Model	TM30 Series
Category	Measuring Instruments
Language	English