Leister NOVOLAS Basic AT - Page 45

Version 2.1
09/2010
NOVOLAS Basic AT
Operation 45
2 TEMP_2: Error Temperature 2
4 TEMP_3: Error Temperature 3
8 TEMP_4: Error Temperature 4
16 CONTROLTEMP: Temperature Error
in Laser diode
32 CURRENT LIMIT: Current error in
laser diode.
Check configuration. Take note of
the max current
128 CURRENTSOURCE: Common error
in current source
256 CURRENTSOURCE_VERSION:
wrong version of current source.
512 INTERLOCK: Common error in
interlock testing.
Restart. Replace module if
necessary (bei Leister service)
1024 LASERVOLTMAX: Laser voltage
exceeded maximum
Restart. Replace module if
necessary (bei Leister service)
2048 LASERVOLTMIN: Laser voltage
dropped below minimum
Restart. Replace module if
necessary (bei Leister service)
4096 SAFETY: Common error in safety
module.
Restart. Replace module if
necessary (bei Leister service)
8192 CUSTOMERIO LINK: Ethernet
communication with CustomerIO
failed
16384 OPTICINTERFACE_LINK: Ethernet
communication with OpticInterface
(pyrometer) failed
Module interlock error
when using an air
cooled laser
module
(corresponds to
the messages as
provided in register
120, since it refers
to the same laser
module)
32786 ILOPENEDWHENLASERON: The
interlock was opened when the laser
was on
0 NO_ERR: No error.
1 ERR_SAFETY: Common error in
safety interlock
9911 LineBeam Returns a value
describing an
interlock error
when using a
Linebeam
2 ILOPENEDWHENLASERON: Safety
interlock has been opened while
laser was on.