System operation
Chapter 4 - page 16
4
D-H002.0607EN
"Alarms > Report list" menu item"
The "Report list" menu item shows the description of the alarms from the "Alarm list".
"Alarms > Info list" menu item"
The "Info list" menu item is for servicing only.
"Alarms > Reset list" menu item"
The "Reset list" menu item is for engineering only.
24 Memory error
25 Short circuit in motor 1
26 Short circuit in motor 2
27 Communications error/software problem
30 Motor 1 overloaded
31 Motor 2 overloaded
32 Time required for motors to cool
33 Battery is being recharged
34 Battery is full
35 Battery recharge failed/mains voltage too low
36 Factory reset after cooling down
37 Factory reset
38 Recalibrate
39 Not at temperature/connect the brown wire
40 Communications error with "dump mode"
41 Communications error with "set mode"
42 Difference between charger/battery voltages too great
Table 4.3 Alarms and codes
Alarm code Description
To Next Page
Loading...
