4 Commissioning
4.1 Preparing an attachment
4.1.1 Check machine for completeness
Scope of delivery and equipment of the machine may vary depending
on the conguration of the purchase order.
1. Make certain that all LEMKEN original parts are present according
to the purchase order.
2. Make certain that all parts are undamaged and correctly mounted
(see corresponding mounting instructions if applicable).
3. Make certain that all other applicable documents are present in the
correct language.
Ä
Chapter 1.4 ‘Further applicable documents’ on page 5
4.1.2 Ensuring suitability of the tractor
4.1.2.1 Checking preconditions
WARNING
Risk of accident due to unsuitable tractor
If the tractor is not suitable for the machine, compo‐
nents of the machine may be overloaded and the tractor-
machine combination may not be steered safely.
This may result in accidents with injuries or death of
persons or damage to the machine.
– Prior to attachment, it must be ensured that the
tractor is suitable for use with machine.
Checklist for compatibility of the tractor for a machine with headstock
Assembly group Requirement Check
Tractor power
Ä
Chapter 12.6 ‘Perform‐
ance data’ on page 80
The tractor power must be within the permissible power range.
c
The tractor power is sucient for the consumers of the connected
machine.
c
Connections of the
machine to the tractor
Ä
Chapter 12.11 ‘Con‐
necting systems at the
machine’ on page 82
The categories of the three-point linkage of the tractor as well as of
the cross shaft and the top link pin of the machine must match.
c
Commissioning
en-GB | Item no. 17516276 | BA 01/2023-09 26
To Next Page
