6.3 Working with the machine
6.3.1 Standard procedure
1. Position the tractor-machine combination.
2. If present, remove the safety guards.
3. With folding machine: Fold out machine.
4. Set the machine.
5. During forward travel, insert the machine into the soil.
6.
Soil cultivation:
n Drive the tractor over the land worked on.
n Keep to the recommended operating speed.
n Adapt the speed to the actual terrain.
n Observe the working result.
n Observe faults:
– Blockages
– Triggered overload safety devices
– Sheared o shear bolts
n Monitor hazardous areas. If necessary, stop and discontinue
soil cultivation.
7. When reaching the headland: Lift the machine.
8. Once the machine has been lifted out, initiate turning at the head‐
land.
9. Do not reinsert the machine until driving straight forward.
10. On completion of soil cultivation: Clean the machine and remove
coarse dirt.
11. Prepare the machine for road travel.
6.3.2 Driving on the headland
1. Before the headland:
Lift the machine fully.
ATTENTION: If parts of the machine come into contact with the
ground, the machine components may be damaged when turning.
2. On the headland:
Adapt the driving speed to the actual ground and soil conditions.
3. After the headland:
Do not lower the machine until driving straight forward.
Operation
en-GB | Item no. 17516276 | BA 01/2023-09 59
To Next Page
Loading...