5.
Insert the top pins
directly above the carrier to ensure the
weight of the rollers additionally supports the soil penetration of
the machine.
INFORMATION: When the machine is lifted, the free space
between the rollers and the soil is also increased.
6. Secure the pins with linch pins.
INFORMATION: If the machine is equipped with touch wheels, the
setting of the touch wheels must also be adjusted when changing
the working depth.
To prevent the roller from sinking too much when being lifted, the
pins must be inserted as deeply as possible into a hole in the adjusting
plates above the carrier in the working position.
INFORMATION
The pressure load on the rollers is determined by the
position of the top link.
Ä
‘Changing top link mounting position’ on page 35
1. Move the machine to the working position.
ð
The pin is relieved.
2. Unlock and pull out the pin.
3. Insert the pin into a deeper hole of the adjusting plates.
4. Secure the pin.
Hydraulic rams are used to adjust the desired depth adjustment as
required.
Example image
Lowering depth of rollers
Hydraulic working depth adjustment
Operation
en-GB | Item no. 17516276 | BA 01/2023-09 49
To Next Page
