Lennox icomfort Touch - Reconfiguring a system; Start system configuration

icomfort Touch 7−Day Programmable Communicating Thermostat
Page 17
Reconfiguring a system
If any component of the HVAC system has been changed,
e.g. replacing an outdoor sensor, reconfiguring the system
will be required. To begin reconfiguring a system, press the
setup tab.
The Start system configuration" screen (figure 47) will ap-
pear. Press start to proceed.
press start button below only if you wish to setup a
new system, or to re−setup an existing system
setup
tests
HELPtests equipment
start
back
Figure 47. Start system configuration
If this is the first attempt to configure a system, the screen will
change to the system discovery screen.
The Re−configure confirmation" screen (figure 48) will only
appear on attempts to RE−CONFIGURE the system. It is a
reminder that system configuration may affect some existing
device settings and prompts to confirm or cancel the config-
uration process (returns to figure 47).
Press confirm to continue system configuration; the screen
will change to the system discovery screen.
configuring the system may affect some device settings.
confirm to continue, or press cancel
setup HELPtests equipment
confirm cancel
Figure 48. Re−configure confirmation
SYSTEM DISCOVERY IN PROGRESS
01.60.00.9999
Figure 49. System discovery indicator
While reconfiguring, the thermostat will have retained set-
tings from the previous configuration. If a device has been re-
placed and re−configuration has detected its replacement de-
vice, it will know the original device is missing and prompt the
installer (figure 50).
If this is the initial configuration, the Compatible device
found" screen does not appear.
Missing
Device Equipment Type No.
Model No.(control model no.)
Serial No. (control serial no.)
Found Compatible
Device Equipment Type No.
Model No.(control model no.)
Serial No. (control serial no.)
setup HELP
Settings were not copied
next
Figure 50. Compatible device found
Press next to accept the device and write the thermostat’s
settings from the previous configuration to the found compat-
ible device. The display changes to Settings were copied".
Press next to advance to the next screen.
Figure 51 lists all communicating devices found and gives you
an opportunity to review the reconfigured devices. Use the ar-
row buttons to scroll through the list of items found on the left
of the screen. Press about to highlight an option on the right
side of the screen and view details about that device. If neces-
sary, change SYSTEM settings as described on Page 10.
setup HELP
press about" for more
information on a high-
lighted device
system devices
next stepback
about
HP
XP17−036−230−01
8408M12345
Furnace
SLP98UH−
090V36C−01
Thermostat
49W95
A110A00070
reset alledit
Figure 51. System devices screen
Press next step to continue to test the system (see Page 11).