Lennox V0STAT51P-2 - Set Temperature Setpoint Range

48
Set Temperature Setpoint Range
Set the unit of temperature to be displayed on the controller.
1. Tap the Menu button on the Home screen.
2. Tap the Service button and then enter your password.
3. Tap the Setpoint Limit button.
4. Tap the up-arrow and down-arrow buttons to set limits for the cooling setpoint. During auto,
cooling or dry mode, the temperature setpoint cannot be set lower than this value.
5. Tap the up-arrow and down-arrow buttons to set limits for the heating setpoint. During auto or
heating mode, the temperature setpoint cannot be set higher than this value.
NOTE - The setpoint range is 62°F to 86°F (17°C to 30°C). This is the default setting.
NOTE - Scheduled operation is not aected by these settings.
Figure 52. Set Temperature Setpoint Range