Server model: eight 2.5-inch SAS/SATA drives, eight 2.5-inch SAS/SATA/NVMe drives, the rear hot-
swap drive assembly, one 24i RAID adapter, one NVMe switch adapter
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the cable
7 might not be available
on your server.
Figure 41. Cable routing for server models with eight 2.5-inch SAS/SATA drives, eight 2.5-inch SAS/SATA/NVMe drives,
the rear hot-swap drive assembly, one 24i RAID adapter, and one NVMe switch adapter
Cable
From To
1 Power cable for front backplane 1 Power connector on front backplane
1
Backplane power connector 1 on the
system board
2 SAS signal cable for front
backplane 1
SAS 0 and SAS 1 connectors on front
backplane 1
C0 and C1 connectors on the 24i
RAID adapter installed in PCIe slot 6
3 NVMe signal cable for front
backplane 1
NVMe 0, NVMe 1, NVMe 2, and
NVMe 3 connectors on front
backplane 1
NVMe 0–1 and NVMe 2–3 connectors
on the system board
4 NVMe signal cable for front
backplane 2
NVMe 0, NVMe 1, NVMe 2, and
NVMe 3 connectors on front
backplane 2
C0, C1, C2, and C3 connectors on
the NVMe switch adapter installed in
PCIe slot 5
5 SAS signal cable for front
backplane 2
SAS 0 and SAS 1 connectors on front
backplane 2
C2 and C3 connectors on the 24i
RAID adapter installed in PCIe slot 6
Chapter 2. Server components 69
To Next Page
Loading...
