Figure 126. System board air baffle removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the system board air baffle and the power interposer
Use this procedure to install the system board air baffle and the power interposer.
Before installing the system board air baffle:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install the system board air baffle, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku: http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. Slightly slide power supply 2 out from the power supply bay (see “Remove a hot-swap power
supply unit” on page 106).
Step 2. Align the power interposer to the server, and lower it until it sits firmly in place.
130
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
